Staub-electronics SM-PROJ-XL-BLK STRONG - UNIVERSAL FINE ADJUST PROJ Manual do Utilizador descarregar pdf (Página 7)

Pg. 7

SM-PROJ-XL Installation Manual

www.snapav.com Support: 866.838.5052

Center of Balance

(D)x4

(F)x4

Projection Screen

Point arrows on

mounting base (C)

toward screen

Afterthecenterofbalanceisfound,themountingbaseassemblymustbeattachedtotheprojector.Attachment

willvaryforalmosteveryprojector,sothepositionofthearmscanbere-conguredasneeded.

Step 5. Attaching the Mounting Base Assembly to the Projector

A. Loosenthefourbolts(F)holdingthearms(D)inplace

to allow enough movement for alignment, then lay the

mountingbaseassemblyoverthecenter-of-gravitymark

on the projector and position the arms over the mounting

points.

 I. Ifthearmswillnotreachalltheholes,theycanbe

movedandre-attachedinanyoftheotherslotson

themounting baseplate. If a projector has only 3

holes,simplyremovetheun-neededarm.

 II. If an arm is protruding too far out (where it would

be visible from below the projector), that arm can

be moved to a different slot to allow for a cleaner

arrangement.

B. Aftertheideallocationforthearmsisfound,tightenthe

armscrews(F)usinga#2Phillipsscrewdriver.

C. Parts (K) through (X) are the screws and washers

included for attachment of the mount to the projector.

There are several lengths in each thread size included

forusewiththespacers(I)ifneeded.Testthescrews

in the projector mounting holes until the thread pattern is

found.

D. Attachthemountingassemblyusingthelongestscrews

with the correct thread pitch that will not bottom out in the

projector, but will still tighten completely. Use up to two

spacers(I)betweeneacharmandtheprojectortoclear

protrusions if needed.

Note: SeeFigure9foranexampleoftheattachment

of the arm to the projector body.

  IftheM3orM4(LthroughQ)screwsareused

for attachment, use the washers (K) between

the screw head and the arms.

  IftheM5orM6screws(RthroughX)areused

thennowasherisrequired.

Figure 8

Figure 9

Use spacers (I) to

adjust clearance

between mount

and projector

M5 and M6 Bolts

(R through X)

Use Washer (K)

with M3 and M4

Bolts (L through Q)

1 2 3 4 5 6 7 8 9 10 11 12

Comentários a estes Manuais

Sem comentários

Staub-electronics SM-PROJ-XL-BLK STRONG - UNIVERSAL FINE ADJUST PROJ Manual do Utilizador Página 7

Comentários a estes Manuais

Manuais e produtos relacionados com Projetores Staub-electronics SM-PROJ-XL-BLK STRONG - UNIVERSAL FINE ADJUST PROJ